Boost Buck XL6009 DC-DC Step Up/Down Converter ( 20W 5-32V to 1.2-35V )

MD0246

New product

More info

Detail about Boost Buck XL6009 DC-DC Step Up/Down Converter ( 20W 5-32V to 1.2-35V )

Descriptions

  •  The new original XLSEMI chip, eliminate fake, disassemble chip.   
  •  Imported SMD electrolytic capacitors, not accompanied by homemade capacitance.   
  •  Up to 400Khz operating frequency, and LC filter circuit, output ripple is very low.   
  •  Import TDK inductors, the heat and noise to a minimum.   
  •  Input and output three MLCC Multilayer ceramic capacitors, interference enhance stability.  
  •  PCB use kb of A grade sheet material, to prevent cardboard, garbage plate.  
  •  Built-in MOSFET, the LM2577 built-triode say goodbye, can reach 94% efficiency.   
  •  Increased enable the port, you can control whether the boost circuit.   
  •  Dimensions: 49 (L) * 23.4 (W) * 11.4 (H) mm (excluding potentiometer) 
 

Parameters

  • Module Properties: non-isolated step-up & down module (BOOST & Buck) 
  • Input voltage: 3.2-32V   
  • Output voltage: (1) continuously adjustable (1.2-35V)   
  • Output Current: 1.5A (MAX)   
  • Input Current: 4A (MAX)   
  • Output power: natural cooling 20W, plus heat sink 25W (MAX) real power   
  • Maximum output power = input voltage conversion efficiency * 4A *conversion efficiency   
  • Conversion efficiency: the efficiency of the measured voltage and current commonly used (hereinafter, for reference only) 
  •  A=Input voltage. B=Input Current. C=Output voltage. D=Output Current. E=conversion efficiency
  • Operating temperature: Industrial grade (-40 C to + 85 C) (ambient temperature exceeds 40 degrees, lower power use, or to enhance heat dissipation)   
  • Full load temperature rise: 45 C   
  • Operating frequency: 400khz   
  • Load current: 5V turn 12V 15mA   
  • Load regulation: ± 0.5%   
  • Voltage regulation: ± 0.5%   
  • Dynamic response speed: 5% 200uS   
  • Enable Control Port: Yes, high 1.4V-VIN (ON), low 0-0.8V (OFF), the default high   
  • Short circuit protection: None (Please install fuse or protection circuit input)   
  • Input reverse polarity protection: None, please with our reverse protection diode board or in the input series.  
  • Installation: You can screw (Fixing holes 3 mm), 2 fixing holes

Reviews

No customer reviews for the moment.

Write a review

Boost Buck XL6009 DC-DC Step Up/Down Converter ( 20W 5-32V to 1.2-35V )

Boost Buck XL6009 DC-DC Step Up/Down Converter ( 20W 5-32V to 1.2-35V )

30 other products in the same category:

Customers who bought this product also bought: